Violation code

393.70B1I

Defective latching fasteners - Fasteners on either side of the vehicle are missing or ineffective

Vehicle Maintenance3Non-OOS· SMS Appendix A v3.20

393.70B1I is a Coupling Devices violation under 49 CFR §393.70B1I. It falls in the Vehicle Maintenance BASIC with a severity weight of 3/10. Nationally it was cited 5,723 times in the last five years, with an OOS rate of 57.8%.

📊

National roadside inspection stats

as of 6/20/2026

Inspections

5,405

that found this code

Violations

5,723

total written

OOS rate

57.8%

3,309 OOS

Source: FMCSA roadside inspection data (last 5 years). The OOS rate is the share of these violations that led the officer to mark the driver or vehicle out of service.

Violation group: Coupling Devices
Regulation §: 393.70B1I
Severity weight: 3
Used in SMS: Yes
Status: Active
Updated: 6/20/2026

Last updated June 2026

⚡

Think this violation was written incorrectly?

Generate a polished DataQs challenge letter for 393.70B1I in about 5 seconds. AI quotes the CFR, predicts your grant chance.

⚡ Draft a challenge →

Notes

DSMS: Y | Comment: Added in 3.0.4; updated description in 3.11 | Footnote: This violation took effect in SMS as of August 28, 2015. The description for this violation was updated in SMS with the September 25, 2020 snapshot.

📚

Challenging 393.70B1I through FMCSA DataQs

If this violation was written incorrectly, here are the angles trucking-safety managers use to contest it. Playbook: Vehicle Maintenance (general).

Common ways to challenge this code

Pre-trip inspection showed compliant brakes
The driver's pre-trip DVIR documented compliant brake adjustment and operation. The cited defect arose en route or was misclassified at roadside.
Evidence that wins
- ✓Driver Vehicle Inspection Report (DVIR) from that date
- ✓Repair invoice or shop record
- ✓Post-citation re-inspection certificate (clean)
Momentary failure exception (§393.9)
The required lamp was inoperative only momentarily due to vibration, temperature, or similar transient cause — explicitly exempted under §393.9.
Evidence that wins
- ✓Photograph showing the lamp operable before / after the stop
- ✓Repair invoice if a fuse or bulb was replaced
Tread measurement disputed
The tread depth measurement was taken at a worn point that is not representative, contrary to NHTSA/FMCSA measurement standards.
Evidence that wins
- ✓Independent tread gauge reading from same tire (multiple positions)
- ✓Photograph of the tire with a reference scale
Documented maintenance schedule disproves the defect
Carrier's periodic-inspection records show the cited defect could not reasonably have existed at the time of inspection.
Evidence that wins
- ✓Periodic inspection certificate (§396.17)
- ✓Maintenance work order proximate to inspection date

Common pitfalls — avoid these

⚠DataQs cannot remove a violation simply because the defect was repaired after the stop

⚡ Draft a challenge for 393.70B1I →Read the DataQs guide first

More codes in Vehicle Maintenance

Same BASIC category — ranked by national citation volume

View all Vehicle Maintenance codes →

❓

Frequently asked questions about 393.70B1I

What does violation 393.70B1I mean?

393.70B1I is the FMCSA roadside-inspection violation code for "Defective latching fasteners - Fasteners on either side of the vehicle are missing or ineffective", part of the Coupling Devices group, cited under 49 CFR §393.70B1I.

What BASIC does 393.70B1I affect?

393.70B1I falls under the Vehicle Maintenance BASIC in the FMCSA Safety Measurement System (SMS).

What is the CSA severity weight of 393.70B1I?

393.70B1I carries a severity weight of 3 out of 10. Higher weights indicate violations more closely tied to crash risk, and they count more toward a carrier's Vehicle Maintenance score.

Is 393.70B1I an out-of-service (OOS) violation?

No. 393.70B1I is not an out-of-service violation, so on its own it does not trigger an out-of-service order at the roadside.

How many CSA points does 393.70B1I add to a carrier's score?

The point contribution of 393.70B1I depends on its severity weight (3/10) multiplied by a time weight of 3, 2, or 1 based on how recent the inspection is. You can calculate the exact contribution with the CSA points calculator.

Can 393.70B1I be challenged through DataQs?

Yes. If you believe 393.70B1I was recorded in error, you can file a Request for Data Review (RDR) through the FMCSA DataQs system with supporting evidence. A successful challenge can remove or correct the violation on your record.

Keep going

CSA points calculator How to challenge a violation Draft a DataQs letter for 393.70B1I Vehicle Maintenance BASIC Carrier CSA lookup CSA glossary

393.70B1I

National roadside inspection stats

Challenging 393.70B1I through FMCSA DataQs

Pre-trip inspection showed compliant brakes

Momentary failure exception (§393.9)

Tread measurement disputed

Documented maintenance schedule disproves the defect