CSA
Violation code

393.70C-CDHSLMII

Full Trailer - Loose mounting, missing or ineffective fasteners, insecure latch, or not in use when required.

Vehicle Maintenance3Non-OOS· SMS Appendix A v3.20

393.70C-CDHSLMII is a Coupling Devices violation under 49 CFR §393.70C-CDHSLMII. It falls in the Vehicle Maintenance BASIC with a severity weight of 3/10. Nationally it was cited 227 times in the last five years, with an OOS rate of 93.8%.

📊

National roadside inspection stats

as of 9/20/2026

Inspections

227

that found this code

Violations

227

total written

OOS rate

93.8%

213 OOS

Source: FMCSA roadside inspection data (last 5 years). The OOS rate is the share of these violations that led the officer to mark the driver or vehicle out of service.

Violation group
Coupling Devices
Regulation §
393.70C-CDHSLMII
Severity weight
3
Used in SMS
Yes
Status
Active
Updated
9/20/2026

Last updated September 2026

Think this violation was written incorrectly?

Generate a polished DataQs challenge letter for 393.70C-CDHSLMII in about 5 seconds. AI quotes the CFR, predicts your grant chance.

⚡ Draft a challenge →

Notes

DSMS: Y | Comment: Added in 3.15; updated description in 3.19 | Footnote: As of February 1, 2023, the violations in this table are included in SMS. Only violations cited on or after February 1 are included in SMS calculations. This update aligns SMS with how violations are being cited in a new software used for roadside inspections. The description for this violation was updated in SMS with the September 27, 2024 snapshot.

What 393.70C-CDHSLMII means — and how to avoid it

In plain English

In plain terms, 393.70C-CDHSLMII is cited for full Trailer - Loose mounting, missing or ineffective fasteners, insecure latch, or not in use when required. It falls under the FMCSA rules on parts and accessories needed for safe operation.

What the inspector checks

  • Cracked/broken wheels or rims
  • Loose, missing, or damaged lug nuts/studs
  • Oil/grease leaks from the hub and bearing play

How to prevent it

  • Check for shiny/streaked lug nuts (a loose-wheel tell) on the walk-around
  • Torque wheels after any service and re-torque per schedule
  • Watch hubs for leaks and address bearing noise early

How it affects your CSA

up to 9 pts (fresh)

Severity 3/10. A fresh citation counts at the 3× time weight — up to 9 points toward the Vehicle Maintenance BASIC — then tapers to 2× after 6 months and 1× after a year, dropping off the score at 24 months.

General guidance from the violation’s FMCSA classification — not legal advice, and not a substitute for the inspector’s findings or 49 CFR.

📚

Challenging 393.70C-CDHSLMII through FMCSA DataQs

If this violation was written incorrectly, here are the angles trucking-safety managers use to contest it. Playbook: Vehicle Maintenance (general).

Common ways to challenge this code

  • Pre-trip inspection showed compliant brakes

    The driver's pre-trip DVIR documented compliant brake adjustment and operation. The cited defect arose en route or was misclassified at roadside.

    Evidence that wins

    • Driver Vehicle Inspection Report (DVIR) from that date
    • Repair invoice or shop record
    • Post-citation re-inspection certificate (clean)
  • Momentary failure exception (§393.9)

    The required lamp was inoperative only momentarily due to vibration, temperature, or similar transient cause — explicitly exempted under §393.9.

    Evidence that wins

    • Photograph showing the lamp operable before / after the stop
    • Repair invoice if a fuse or bulb was replaced
  • Tread measurement disputed

    The tread depth measurement was taken at a worn point that is not representative, contrary to NHTSA/FMCSA measurement standards.

    Evidence that wins

    • Independent tread gauge reading from same tire (multiple positions)
    • Photograph of the tire with a reference scale
  • Documented maintenance schedule disproves the defect

    Carrier's periodic-inspection records show the cited defect could not reasonably have existed at the time of inspection.

    Evidence that wins

    • Periodic inspection certificate (§396.17)
    • Maintenance work order proximate to inspection date

Common pitfalls — avoid these

  • DataQs cannot remove a violation simply because the defect was repaired after the stop

More codes in Vehicle Maintenance

Same BASIC category — ranked by national citation volume

View all Vehicle Maintenance codes

Other Coupling Devices codes

Codes under the same FMCSA violation group

Frequently asked questions about 393.70C-CDHSLMII

What does violation 393.70C-CDHSLMII mean?

393.70C-CDHSLMII is the FMCSA roadside-inspection violation code for "Full Trailer - Loose mounting, missing or ineffective fasteners, insecure latch, or not in use when required.", part of the Coupling Devices group, cited under 49 CFR §393.70C-CDHSLMII.

What BASIC does 393.70C-CDHSLMII affect?

393.70C-CDHSLMII falls under the Vehicle Maintenance BASIC in the FMCSA Safety Measurement System (SMS).

What is the CSA severity weight of 393.70C-CDHSLMII?

393.70C-CDHSLMII carries a severity weight of 3 out of 10. Higher weights indicate violations more closely tied to crash risk, and they count more toward a carrier's Vehicle Maintenance score.

Is 393.70C-CDHSLMII an out-of-service (OOS) violation?

No. 393.70C-CDHSLMII is not an out-of-service violation, so on its own it does not trigger an out-of-service order at the roadside.

How many CSA points does 393.70C-CDHSLMII add to a carrier's score?

The point contribution of 393.70C-CDHSLMII depends on its severity weight (3/10) multiplied by a time weight of 3, 2, or 1 based on how recent the inspection is. You can calculate the exact contribution with the CSA points calculator.

How can a driver prevent 393.70C-CDHSLMII?

Check for shiny/streaked lug nuts (a loose-wheel tell) on the walk-around; Torque wheels after any service and re-torque per schedule; Watch hubs for leaks and address bearing noise early.

Can 393.70C-CDHSLMII be challenged through DataQs?

Yes. If you believe 393.70C-CDHSLMII was recorded in error, you can file a Request for Data Review (RDR) through the FMCSA DataQs system with supporting evidence. A successful challenge can remove or correct the violation on your record.

Keep going

Turn this violation into a training moment

Assign training on this exact topic — and prove it

Looking up a code is step one. FleetTrained — built by the same safety manager behind VioCodes — lets you assign a video on this topic; drivers quiz and sign in their language, and you get a DOT-ready certificate so it stops happening.

Flat monthly · unlimited driversCertificates · any language
Explore FleetTrained

Field notes & comments

0 comments
Sign in to add a field note.
  • No comments yet — be the first.

Statistics

Most-cited violation codes

Ranked by roadside-inspection citation count across FMCSA public data.